How to install driver of optical-network-card and setup the ip-config
From cslt Wiki
Revision as of 12:03, 5 December 2018 by Zhangzy
Optical port network card plugging
- First verify the type of your Optical-network, usually PCI-E (x8/x16).
- Scan the mother-board to check if there are any PCI-E(x8/x16) left, then plug the card to the match one.
- Run "lspci |grep net" to see the numbers of network-card.
* First check the chip-type and adapter-type of the network-card. * Go to https://www.intel.com/content/www/us/en/support/products/36773/network-and-i-o/ethernet-products.html to find the corresponding drivers. * Download the source code of driver and then compile it on your target machine according to the README in src ** make ** make install