Difference between revisions of "How to install driver of optical-network-card and setup the ip-config"

From cslt Wiki
Jump to: navigation, search
Line 1: Line 1:
# Optical port network card plugging
+
== Optical port network card plugging ==
  * First verify the type of your Optical-network, usually PCI-E (x8/x16).
+
# First verify the type of your Optical-network, usually PCI-E (x8/x16).
  * Scan the mother-board to check if there are any PCI-E(x8/x16) left, then plug the card to the match one.
+
# Scan the mother-board to check if there are any PCI-E(x8/x16) left, then plug the card to the match one.
# Driver install(ixgbe)
+
# Run "lspci |grep net" to see the numbers of network-card.
 +
 
 +
== Driver install(ixgbe) ==
 
   * First check the chip-type and adapter-type of the network-card.
 
   * First check the chip-type and adapter-type of the network-card.
 
   * Go to https://www.intel.com/content/www/us/en/support/products/36773/network-and-i-o/ethernet-products.html to find the corresponding drivers.
 
   * Go to https://www.intel.com/content/www/us/en/support/products/36773/network-and-i-o/ethernet-products.html to find the corresponding drivers.
Line 8: Line 10:
 
     ** make
 
     ** make
 
     ** make install
 
     ** make install
 +
 
#
 
#

Revision as of 12:03, 5 December 2018

Optical port network card plugging

  1. First verify the type of your Optical-network, usually PCI-E (x8/x16).
  2. Scan the mother-board to check if there are any PCI-E(x8/x16) left, then plug the card to the match one.
  3. Run "lspci |grep net" to see the numbers of network-card.

Driver install(ixgbe)

 * First check the chip-type and adapter-type of the network-card.
 * Go to https://www.intel.com/content/www/us/en/support/products/36773/network-and-i-o/ethernet-products.html to find the corresponding drivers.
 * Download the source code of driver and then compile it on your target machine according to the README in src
   ** make
   ** make install